The IN-WATER MOORING STATION
virtually eliminates bottom fouling
without the need for bottom painting or hull scraping.
Four years experience with hundreds of customers
from Australia to the Canary Islands. No matter how often a boat
is moved or how long it is stored, barnacles do not grow on a boat in the MOORING
STATION.
NOT ONE BARNACLE.
How does the In-Water Mooring Station work?
The MOORING STATION isolates the water
in
contact with the boat hull from the surrounding
water.
This isolation prevents water flow, so oxygen
and food sources are not replenished.
A clarifier is all
that is needed to keep the water clear. This virtually
eliminates all marine
biofouling from your hull.
The MOORING STATION floats in the water with
an undershield
that is below the props and keel. It has
a rear tailgate that lowers to allow
access; and rises to
completely isolate the water in the MOORING STATION.
The boat floats inside the MOORING STATION.
The boat
hull is clean and protected.
No bottom paint. No hull scraping. No lift.
Low maintenance. Easy installation.
Cost effective.
• Save Money – Experience has shown that today’s bottom paints last between 18
and 24 months in salt water, after
which the paint has lost effectiveness, and the boat is
hauled out, scraped, refinished, and repainted. Plus, while the boat is
in the water, the hull may have to be scraped as often as 14 times a year by a diver to keep growth off
the hull. This is an inwater
operation which many states are now prohibiting. Keeping
the hull clean costs from $50 to $100 per foot per year.
From this standpoint alone, the MOORING STATION should
pay for itself in 18 to 24 months.
• Higher Resale Value by 10%
to 30% without bottom paint. Better Economy by 3% to 8% without bottom paint
(OVER
$0.35/gallon in today’s market).
• No need for an expensive boat lift – Your In-Water Mooring Station will cost a fraction of a lift. You can install it
yourself. Easy to move and remove whenever you want. It is not permanent. Simply tie it off to your dock or pier
as you
would your boat. Many marinas and Home Owner’s Associations prohibit
lifts. Generally, no permit required.
• Safer for you and your boat – The In-Water Mooring Station will protect your boat hull from floating debris, garbage,
slime, and fuel and oil spills. Cross winds and currents when you dock? Not a problem. The MOORING STATION will help
guide you into your slip. Worried about pulling up onto a floating lift? Never again.
Your boat floats in the water – where it
was meant to be. Forget about driving
your boat onto a hard surface lift. Your boat is perfectly protected in the water.
• Suitable for all boats – Motor boats, sail boats, performance boats, pontoon boats, house boats, live-aboards,
catamarans, and personal water craft – in fresh or salt water. Bottom painted boats benefit by eliminating
hull scraping.
•
Installs easily with minimal maintenance – Weighs
under 100 pounds. Easy to ship, install, operate, move and
remove. Assembles in less than three man-hours.
Not a permanent installation. Does not lift the boat. Does
not require a
licensed or certified installer. Add a water clarifier if desired. Clean annually if needed. Avoids most permitting and
home owner association issues.
• Better for the environment – No toxic chemicals required. No need to drain or add water
either. No more toxic
bottom paint and no more hull scraping means less toxic chemicals
in the waters, canals, boatyards and marinas. Better for
marinas. Better for waterways. Better
for you.
• Our
Guarantee – We KNOW that you will be satisfied
with your In-Water Mooring Station. If for ANY REASON you
are dissatisfied with your MOORING STATION in the first 60 days, we’ll give you a full refund. No questions asked. Our
MOORING STATION comes with a limited two year warrantee. 10 year UV protection with same material as
inflatable boats.
